[vsnet-grb 98061] Status of the INTEGRAL-SPIACS problem
Bacodine
vxw at capella.gsfc.nasa.gov
Mon May 4 12:38:33 JST 2009
TO: All INTEGRAL-SPIACS recipients
RE; Lots of SPIACS Notices
DT: 04 May 09
If you do not receive GCN/INTEGRAL-SPIACS Notices
you can hit delete now.
At 13:02 UT 02may09, the INTEGRAL IBAS system started sending SPI-ACS Notices to GCN
at an average rate of one every 3-5 minutes.
Given the weekend and day-night cycles, initial communications with INTEGRAL Operations
did not yield an timely reply. So I activated the blocked-to-world filter
for the SPIACS Notice type at 12:27 UT 03may09.
INTEGRAL Operations is now aware of the problem, and they have blocked
the generation/sending of the SPIACS messages to GCN.
The generation of the SPIACS messages had somethingto do with the SPI instrument
being in an annealing mode of operations. When the anealing is done,
they will re-activate the SPIACS message type at their end. (I have already
removed the block-to-world filter at the GCN end since the messages
are no longer being generated.)
Sincerely,
Scott
Scott Barthelmy NASA-GSFC, Code 661, Greenbelt, MD 20771
PHONE: 301-286-3106 (office) CELL: 301-346-3733
FAX: 301-286-1684 (1st choice, -1682 2nd choice)
EMAIL: scott at lheamail.gsfc.nasa.gov
PAGER: 3013463733 at cingularme.com
WEB: http://gcn.gsfc.nasa.gov/gcn
Site_name: VSNET
Lon,Lat= 135.75 35.00
Distribution_method: EMAIL Attachment_format: NONE
Address: vsnet-grb at ooruri.kusastro.kyoto-u.ac.jp
Filter: ALL
Error_limit= 360.100 [deg, diameter]
Delta_T_limit= 999.900 [hr]
Swift_Trigger_ID_filter: Disabled
Sources & Notice Types/Subtypes:
RXTE-PCA_Alert_wont: Disabled
RXTE-PCA_Alert_will: Disabled
RXTE-PCA_nosaw: Enabled
RXTE-PCA_saw: Enabled
RXTE-ASM: Enabled
IPN_RAW: Disabled
IPN_POS: Enabled
RXTE-ASM_TRANS: Enabled
HETE_TEST: Disabled
TYPE2_TEST: Disabled
INTEGRAL_Test_notices: Disabled
SWIFT_BAT_GRB_TEST: Disabled
AGILE_GRB_TEST: Disabled
FERMI_GBM_TEST: Disabled
FERMI_LAT_TEST: Disabled
INTEGRAL_POINTDIR: Disabled
INTEGRAL_SPIACS: Enabled
INTEGRAL_WAKEUP: Enabled
INTEGRAL_REFINED: Enabled
INTEGRAL_OFFLINE: Enabled
GRB_CNTRPART: Disabled
SWIFT_BAT_GRB_ALERT: enabled
SWIFT_BAT_GRB_POS: enabled
SWIFT_BAT_GRB_POS_NACK: enabled
SWIFT_BAT_SUBTHRESH_POS: Disabled
SWIFT_BAT_GRB_LIGHTCURVE: enabled
SWIFT_FOM_2OBS: enabled
SWIFT_SC_2SLEW: enabled
SWIFT_XRT_POS: enabled
SWIFT_XRT_POS_NACK: enabled
SWIFT_XRT_SPECTRUM: enabled
SWIFT_XRT_IMAGE: enabled
SWIFT_XRT_LIGHTCURVE: enabled
SWIFT_UVOT_IMAGE: enabled
SWIFT_UVOT_SRCLIST: enabled
SWIFT_UVOT_POS: enabled
SWIFT_UVOT_POS_NACK: Disabled
SWIFT_BAT_GRB_LC_PROC: enabled
SWIFT_XRT_SPECTRUM_PROC: enabled
SWIFT_XRT_IMAGE_PROC: enabled
SWIFT_UVOT_IMAGE_PROC: enabled
SWIFT_UVOT_SRCLIST_PROC: enabled
SWIFT_POINTDIR: enabled
SWIFT_BAT_TRANS: Disabled
SWIFT_BAT_SLEW_POS: Disabled
SWIFT_TOO_FOM: enabled
SWIFT_TOO_SLEW: enabled
AGILE_GRB_WAKEUP_POS: Disabled
AGILE_GRB_GROUND_POS: Disabled
AGILE_GRB_REFINED_POS: Disabled
AGILE_POINTDIR: Disabled
FERMI_GBM_ALERT: Disabled
FERMI_GBM_FLT_POS: Disabled
FERMI_GBM_GND_POS: Disabled
FERMI_LAT_POS_UPD: Disabled
FERMI_POINTDIR: Disabled
SIMBAD-NED: Disabled
General Adminastrivia Comments/Suggestions:
1) When requesting changes to your configuration,
it helps if you refer to your site_name.
2) If your site has more than one recipient (ie a list),
please review the list to see if anybody should be deleted;
(the volume of bounce-back-to-gcn emails gets large after a while).
3) If a new contact_person has taken over for the project, please inform me.
4) If your site is no longer active, please inform me.
More information about the vsnet-grb
mailing list